Weed Wacker How To Restring

Weed Wacker How to Restring

If you’re looking to keep your lawn looking neat and tidy, a weed wacker can be a great tool to have. But if you’re not familiar with how to restring it, you might find yourself struggling to get the job done. In this article, we’ll walk you through the steps of how to restring your weed wacker in a few easy steps.

Step-by-Step Guide

Step 1: Gather Your Supplies

The first thing you’ll need to do is gather all the necessary supplies. This includes a new spool of weed wacker line, a clean work surface, and a pair of scissors or wire cutters.

Step 2: Remove the Spool

The next step is to remove the spool from your weed wacker. This will typically involve unscrewing a cap or pressing a button to release the spool.

Step 3: Clean the Spool

Before you can restring your weed wacker, you’ll need to clean the spool. Use a clean cloth or paper towel to wipe away any dirt, debris, or old line that may be stuck to it.

Step 4: Measure the Line

Once your spool is clean, you can begin to measure out your new line. Cut a length of line that is long enough to fill the spool, but not so long that it will get tangled or cause feeding issues.

Step 5: Thread the Line

Now it’s time to thread the line through the holes on your spool. This will typically involve feeding the line through a hole on the spool, wrapping it around the spool a few times, and then feeding it through another hole.

Step 6: Secure the Line

Once the line is threaded through the spool, you’ll need to secure it in place. This may involve tying a knot or using a clip or other device to hold the line in place.

Step 7: Wind the Line

With the line secured, you can begin to wind it onto the spool. This will typically involve turning a knob or pressing a button to wind the line onto the spool in a tight, even pattern.

Step 8: Cut the Line

Once the line is wound onto the spool, you’ll need to cut it to the appropriate length. Use your scissors or wire cutters to trim the line to the desired length.

Step 9: Reattach the Spool

With your spool freshly wound and cut, you can now reattach it to your weed wacker. This will typically involve screwing the cap back on or pressing the spool back into place.

Step 10: Test Your Weed Wacker

Finally, it’s time to test your weed wacker to make sure everything is working as it should. Turn it on and give it a few practice swings to ensure that the line is feeding properly and that your weed wacker is ready to tackle your lawn.


How often do I need to restring my weed wacker?

You should restring your weed wacker whenever the line runs out, or if you notice that the line is becoming tangled or feeding improperly.

What type of line should I use for my weed wacker?

There are many different types of weed wacker line available, so it’s best to consult your owner’s manual to determine the appropriate type of line for your specific model.

What should I do if my weed wacker line keeps getting tangled?

If you’re experiencing feeding issues or your line keeps getting tangled, it’s possible that the line is not wound tightly enough or that the spool is not properly secured. Try restringing your weed wacker again, and make sure to follow all the steps carefully.


Restringing your weed wacker might seem intimidating at first, but with a little bit of practice, it can become a quick and easy task. By following the steps outlined in this article, you’ll be able to keep your weed wacker running smoothly and ensure that your lawn always looks its best.